show ipv6

 

 

This chapter describes the outputs of the show ipv6 command.

 

show ipv6 interface summary

show ipv6 interface summary Command Output Descriptions

Field	Description
Intf name	Interface name
Intf Type	Interface type
Description
Router Advertisement	Displays whether the system is sending router advertisements. Options are either enabled or disabled.
IP State	Displays the IP state (UP/DOWN) and binding detail
MTU	The subscriber’s maximum transmission unit (MTU) size in octets.
IPv6 Link-Local Address:	Displays the IPv6 link-local address
IPv6 Global Unicast Address:	Displays the ipv6 Global Unicast Address address

‌

 

show ipv6 neighbors

show ipv6 neighbors Command Output Descriptions

Field	Description
Address	IPv6 address from table
Type	Interface type: • Broadcast (Ethernet) • Loopback
Link address	MAC address
Flags	One of the following flag codes: • I = Incomplete • R = Reachable • M = Permanent • S = Stale • D = Delay • P = Probe • F = Failed
Interface	Interface name

‌

 

show ipv6 route

show ipv6 route Command Output Descriptions

Field	Description
Destination	Designating ipv6 address prefix/length
Next hop	Address of the directly connected next hop interface
Protocol	Connected Unconnected
Prec	Number of precedence bits set
Cost	Number of router hops to destination address
Interface	Name of the next hop interface
Total Route Count	Total number of routes Number connected Number of static routes

‌

 

 

Cisco Systems Inc.

Tel: 408-526-4000

Fax: 408-527-0883